Skinfold Body Fat Calculator
Quick answer: The Jackson-Pollock 3-site skinfold method estimates body fat from three caliper pinches: chest, abdomen, and thigh for men; triceps, suprailiac, and thigh for women. A 30-year-old man with a 47 mm total (12 + 20 + 15 mm) has an estimated body density of 1.0663 and about 14.2% body fat by the Siri equation.
Enter your sex, age, weight, and three skinfold measurements in millimeters to estimate body fat percentage, fat mass, and lean mass with the Jackson-Pollock 3-site formula.
Enter your numbers
Your results
How to use this calculator
Use skinfold calipers at the three sites for your sex: men measure chest (diagonal fold halfway between nipple and armpit), abdomen (vertical fold beside the navel), and thigh (vertical fold on the front of the thigh). Women measure triceps (vertical fold on the back of the upper arm), suprailiac (diagonal fold above the hip bone), and thigh.
Pinch the skin and fat (not muscle), apply the caliper, and read after two seconds. Measure each site twice and enter the average.
How this is calculated
Body density uses the Jackson-Pollock 3-site equations: men, density = 1.10938 − 0.0008267×sum + 0.0000016×sum² − 0.0002574×age; women, density = 1.0994921 − 0.0009929×sum + 0.0000023×sum² − 0.0001392×age, where sum is the three skinfolds in millimeters. Body fat % = 495 ÷ density − 450 (the Siri equation). Fat mass = weight × body fat %; lean mass = weight − fat mass.
Worked example
A 30-year-old man measuring 12 mm (chest), 20 mm (abdomen), and 15 mm (thigh): sum = 47 mm. Density = 1.10938 − 0.0008267×47 + 0.0000016×47² − 0.0002574×30 = 1.0663. Body fat = 495 ÷ 1.0663 − 450 = 14.2%. At 180 lb, fat mass is 25.6 lb and lean mass is 154.4 lb.
Reference data
Formulas used: Jackson-Pollock 3-site body density equations (Jackson & Pollock, 1978/1985) and the Siri equation for converting density to body fat percentage (Siri, 1961). These are published research formulas, reproduced here as the calculator's method.
Source: Jackson, A.S. & Pollock, M.L. (1978); Siri, W.E. (1961). Page built 2026.
Method & sources
Results are estimates for planning. They are general information, not financial, medical, or professional advice.
Frequently asked questions
How accurate are skinfold calipers?
With good technique, skinfold estimates land within about 3–4 percentage points of lab methods like DEXA. The biggest error source is inconsistent pinching — always measure the same sites the same way and average two readings.
Which sites do men and women measure?
Men: chest, abdomen, and thigh. Women: triceps, suprailiac (above the hip bone), and thigh. The Jackson-Pollock equations are sex-specific because fat distributes differently.
What is the Siri equation?
Body fat % = 495 ÷ body density − 450. It converts the density estimated from skinfolds into a body fat percentage, assuming fixed densities for fat and fat-free tissue.
Do I need to be lean for skinfolds to work?
Skinfolds work across a wide range but lose accuracy at extremes — very high body fat makes pinches hard to isolate, and very low body fat leaves little to pinch. In both cases, treat the result as an estimate and track changes over time rather than the absolute number.
Can I track progress with skinfolds alone?
Yes — the skinfold sum itself is a useful progress metric even without converting to a percentage. If the sum drops while your weight holds, you are losing fat and keeping muscle.