Recessed Lighting Layout Calculator
Quick answer: A reliable recessed lighting rule is to space fixtures about half the ceiling height apart: an 8-foot ceiling gives roughly 4-foot spacing. A 12 by 15 foot room with 8-foot ceilings therefore needs about 12 fixtures โ 3 across and 4 down โ spaced 4 feet by 3.75 feet.
Enter your room dimensions and ceiling height to plan a recessed light layout with even coverage. The calculator spaces fixtures using the ceiling-height rule, then rounds to whole rows and columns so the grid fits your room exactly.
Enter your numbers
Your results
How to use this calculator
Measure the room's length and width in feet and enter the ceiling height. The calculator returns the fixture count and the grid spacing to mark on the ceiling. Start the grid half a spacing out from each wall so the edge fixtures sit the same distance from the wall as from each other.
For task areas such as kitchen counters, shift the grid so fixtures sit over the work surface rather than centered on the room.
How this is calculated
Target spacing = ceiling height รท 2. Fixtures along each side = ceiling of (side length รท target spacing), rounded up so no gap exceeds the target spacing. Actual spacing = side length รท fixture count on that side. Total fixtures = columns ร rows.
This is a layout estimate for general lighting. Brightness depends on bulb lumens, beam angle, and wall color, which this calculator does not model.
Worked example
A 12 by 15 foot room with 8-foot ceilings: target spacing = 8 รท 2 = 4 feet. Fixtures along the 15-foot side = ceil(15 รท 4) = 4; along the 12-foot side = ceil(12 รท 4) = 3. Total = 4 ร 3 = 12 fixtures, at actual spacings of 15 รท 4 = 3.75 feet and 12 รท 3 = 4 feet.
Reference data
Planning constants used by this calculator: spacing factor = ceiling height รท 2; wall offset = half the fixture spacing. These are layout rules stated as calculator assumptions, not code requirements โ local electrical codes govern wiring, circuit load, and clearance from insulation and joists.
Source: calculator assumptions stated above (2026 build); verify circuit and clearance rules against local electrical code before installing.
Method & sources
Results are estimates for planning. They are general information, not financial, medical, or professional advice.
Frequently asked questions
How far apart should recessed lights be?
A widely used layout rule is half the ceiling height: 4 feet apart for 8-foot ceilings, 4.5 feet for 9-foot ceilings, and 5 feet for 10-foot ceilings. Wider spacing leaves dark patches; tighter spacing wastes fixtures.
How far should recessed lights be from the wall?
About half the fixture spacing โ 2 feet from the wall when fixtures are 4 feet apart. This keeps the edge of the room as bright as the center instead of leaving a dark border.
How many recessed lights do I need for a 12x12 room?
With 8-foot ceilings, target spacing is 4 feet, so a 12 by 12 foot room needs 3 by 3 = 9 fixtures. With 9-foot ceilings the spacing grows to 4.5 feet, giving 3 by 3 = 9 fixtures at 4-foot actual spacing.
Does beam angle change the spacing?
Yes. Narrow-beam (flood) fixtures need tighter spacing than wide-beam (flood) fixtures for the same evenness. The half-height rule assumes a standard 60-degree beam; for narrow beams, reduce spacing by about 25%.
Can I put recessed lights in any ceiling?
The ceiling needs clearance above it for the fixture housing and must meet local code for insulation contact (IC-rated housings where insulation is present). Always check joist spacing and local electrical code before cutting holes.